Troubleshooting Guide - laguna CFLUX1 Manual

TROUBLESHOOTING GUIDE

Symptom Possible Cause
Machine Power supply switched
does not OFF or is faulty.
start or a
breaker
Wall fuse/circuit breaker is
trips.
blown/tripped.
Faulty remote control.
Remote receiver is faulty.
Incorrectly wired motor
connection.
On-board circuit breaker is
tripped.
Wiring is open/has high
resistance.
Faulty power switch.
Motor is at fault.
Excessive Loose component.
vibration or
noise during
operation.
Loose or broken motor
mount.
Motor fan hitting fan
cover.
Bad motor bearings.
Possible Solution
Ensure power supply is ON and
has the correct voltage.
Ensure adequate circuit size;
install inlet restrictor, replace
weak breaker.
Replace batteries; ensure un-
obstructed line-of-sight and
signal range.
Inspect receiver circuit board;
replace if faulty.
Rewire or call certified service
technician or electrician.
Allow motor to cool, improve
ventilation, press reset button.
Check for broken wires or poor
connections, repair as necessary.
Replace switch.
Test/repair/replace.
Inspect and tighten all bolts/nuts.
Tighten or replace as needed.
Check fan and cover; replace as
needed.
Rotate shaft manually, check for
grinding or loose shaft, replace
bearings if needed.
1.5HP Mobile Dust Cyclone Manual
34