Setup And Assembly; Shipping Contents; Unpacking And Cleanup; Tools Required For Assembly - Jet JWBG-8NW Operating Instructions And Parts Manual

6.0 Setup and assembly

6.1 Shipping contents

Carton contents (see Figure 1)
Qty. Item
1 Bench grinder (not shown)
1 Spark guard – Left (A)
2 Lock knob (B)
1 Spark guard – Right (C)
1 Eye shield bracket – Left (D)
2 Cross head screw 1/4" x 1/2" (E)
1 Eye shield bracket – Right (F)
2 Eye shield plate (G)
4 Socket head cap screw 5/16" x 3/4" (H)
6 Flat washer 5/16" (J)
4 Pan head screw 3/16" x 3/8" (K)
4 Hex head screw 1/4" x 3/8" (L)
6 Flat washer 1/4" (M)
2 Lock washer 1/4" (N)
1 Tool rest – Left (O)
1 Tool rest – Right (P)
1 Tool rest bracket – Left (Q)
1 Tool rest bracket – Right (R)
2 Lock knob (S)
2 Eye shield (T)
4 Flange (U)
NOTE: Grinding wheels are not provided.

6.2 Unpacking and cleanup

Remove all contents from shipping carton. Check
for shipping damage; if any is found report it to
your distributor.
Do not discard carton or packing material until
grinder is assembled and running satisfactorily.
Compare contents of shipping carton with the
contents list above. Report any shortages to your
distributor. (Check grinder first to verify if any parts
have been pre-assembled.)

6.3 Tools required for assembly

1/4" hex key
10mm wrench
1" wrench (or adjustable wrench)
Cross-point screwdriver #1 or #2
Your bench grinder requires only the assembly of
the eye shields, tool rests, and grinding wheels.
Additional tools may be needed for fastening the
grinder to a workbench or stand. For your safety,
do not plug the grinder into a power source until all
assembly and adjustments are complete.
Figure 1: shipping contents (not to scale)
7