Table of Contents
Advertisement
Ethernet
The Bengal features two on-board Intel I210-IT Gigabit Ethernet controllers. The controllers
provide a standard Ethernet interface for 1000Base-T, 100Base-TX, and 10Base-T applications.
Drivers are available to support a variety of operating systems. These interfaces are protected
against ESD damage.
Ethernet Connectors
Two Ethernet interfaces are provided at connector locations J7 (Ethernet 0) and J1 (Ethernet 1).
The I210-IT Ethernet controller auto-negotiates connection speed. VersaLogic cable VL-CBR-
0804 adapts the 8-pin Ethernet connector to an RJ-45 connector. Table 18 lists the pinout of the
J1 and J7 Ethernet connectors. Figure 16 is a side view of the board showing the Ethernet
connectors and their pin configurations.
J1, J7 Pin
1
2
3
4
5
6
7
8
Figure 16. Side View of Board Showing Pin Numbers of the Ethernet Connectors
Bengal (VL-EPMe-30) Reference Manual
Table 18: Ethernet Connector Pinout (J1, J7)
10/100 Signal Name
- Auto Switch (Tx or Rx)
+ Auto Switch (Tx or Rx)
- Auto Switch (Tx or Rx)
+ Auto Switch (Tx or Rx)
- Auto Switch (Tx or Rx)
+ Auto Switch (Tx or Rx)
- Auto Switch (Tx or Rx)
+ Auto Switch (Tx or Rx)
Interfaces and Connectors
10/100/1000 Signal Name
BI_DD-
BI_DD+
BI_DB-
BI_DB+
BI_DC-
BI_DC+
BI_DA-
BI_DA+
VL-CBR-0804
RJ-45 Pin
8
7
6
3
5
4
2
1
36
Advertisement
Table of Contents
