System Ram; Resetting Bios To Factory Defaults; Clearing Cmos Ram And Rtc Registers - VersaLogic VL-EPME-30ECP Hardware Reference Manual

System RAM

The Bengal accepts one 204-pin SO-DIMM memory module (J9 connector) with the following
characteristics:

Size

Voltage

Type

Resetting BIOS to Factory Defaults

Reset the BIOS to default settings using the following the instructions:
1. Power off the Bengal and set SW1 switch position 3 to
the On position (toward the outer edge of the board).
2. Power on the Bengal.
3. After the system boots, power off the Bengal and set
the switch back to the Off position (toward the center
of the board).
4. Power on the Bengal.

Clearing CMOS RAM and RTC Registers

Clear the CMOS RAM and RTC registers (which includes the date/time) using the following the
instructions:
1. Power off the Bengal.
2. Set SW1 switch position 1 to the On position (toward
the outer edge of the board).
3. Wait at least two seconds and set the switch back to
the Off position (toward the center of the board).
4. Power on the Bengal.
Bengal (VL-EPMe-30) Reference Manual
Up to 8 GB, 1066 MHz or 1333 MHz, CPU dependent
1.35 V
DDR3L (VersaLogic VL-MM9 Series modules)
System Features




21