Remove The Sc-Board; Remove The Ss-Board; Remove The Stand Bracket And The Hanger Metals - Panasonic TX-P50UT30 Service Manual

9.10. Remove the SC-Board

1. Remove the SU-Board and SD-Board. (See section 9.8.
and 9.9.)
2. Disconnect the connector (SC2).
3. Disconnect the flexible cable (SC20).
4. Remove the screws (×7

9.11. Remove the SS-Board

1. Remove the Tuner unit. (See section 9.5.)
2. Disconnect the connector (SS11).
3. Disconnect the flexible cable (SS33).
4. Disconnect the flexible cables (SS53, SS54 and SS56).
5. Remove the screws (×5
) and remove the SC-Board.
) and remove the SS-Board.
9.12. Remove the Stand bracket and
the Hanger metals
1. Remove the Plasma panel section from the servicing
stand and lay on a flat surface such as a table (covered
by a soft cloth) with the Plasma panel surface facing
downward.
2. Unlock the cable clampers to free the cable.
3. Remove the AC inlet. (See section 9.2.)
4. Remove the Stand bracket fastening screws (×5
remove the Stand bracket.
5. Remove the Hanger metals (L, R) fastening screws (×2
each) and remove the Hanger metals (L, R).
24
) and