Advertisement
CARE AND MAINTENANCE
To enjoy years of outstanding performance from your heater, make sure you
perform the following maintenance activities on a regular basis:
cleaning agents.
While cleaning your unit, be sure to keep the area around the burner
and control compartment dry at all times. Do not submerge the
control valve assembly. If the gas control is submerged in water, do
NOT use it. It must be replaced.
air passageways clean. Signs of possible blockage include:
Heater does NOT reach the desired temperature.
Heater glow is excessively uneven.
Heater makes popping noise.
condition can damage heater and render it unsafe for use. Clean
burner holes by using a heavy-duty pipe cleaner. Compressed air
may help clear away smaller particles.
screen with warm soapy water if any carbon deposits develop.
Note: In a salt-air environment (such as near an ocean), corrosion
occurs more quickly than normal. Frequently check for corroded areas
and repair them promptly.
Use high-quality automobile wax to help maintain the appearance
of your heater. Apply to exterior surfaces from the post down.
DO NOT apply to emitter screen or domes.
FOR YOUR SAFETY
Do NOT touch or move heater for at
least 45 minutes after use.
:
• Turn control knob OFF.
• Disconnect LP source.
• Store heater upright in an area
sheltered from direct contact
with inclement weather (such
as rain, sleet, hail, snow, dust
and debris).
• If desired, cover heater to
protect exterior surfaces and
to help prevent build-up in air
passages. Never leave LPG tank
exposed to direct sunlight or
excessive heat.
Wait until heater is
cool before covering.
should repair gas passages and
associated components.
Caution: Always allow heater
to cool before attempting
service.
20
Advertisement
