Advertisement
1. Make 2-3 oz. of leak test solution
detergent and three parts water).
2. Apply several drops of solution
where hose attaches to regulator.
3. Apply several drops of solution
where regulator connects to cylinder.
4. Make sure all patio heater valves are OFF.
5. Turn cylinder valve ON.
Turn cylinder valve OFF.
If leak is detected at hose/regulator connection, tighten connection and
perform another leak test. If bubbles continue to appear, call customer service
at (800) 561-5550 7:30 a.m. – 4:00 p.m. PST or email customercare@jrhome.com.
If leak is detected at regulator/cylinder valve connection, disconnect,
reconnect, and perform another leak test. If you continue to see bubbles
after several attempts, cylinder valve is defective. Call our customer service
at (800) 561-5550 7:30 a.m. – 4:00 p.m. PST or email customercare@jrhome.com.
Note: Whenever gas connections are loosened or removed, you must perform
a complete leak test.
This appliance can produce carbon monoxide
which has no odor. Using it in an enclosed
space can kill you. Never use this appliance in
an enclosed space such as a camper, tent or
home.
• Perform all leak tests outdoors.
•
• NEVER leak test when smoking
• Do not use heater until all connections have
been leak tested and show no signs of
leakage.
Caution: Do not attempt to
operate this appliance until you
have read and understand all
Safety Information in this manual
and all assembly is complete and
leak tests have been performed.
Your heater was designed and
approved for
Do NOT use it inside a building,
garage, or any other enclosed
area.
Make sure surrounding areas are
free of combustible materials,
Ensure that there is no obstruction
to air ventilation. Be sure all gas
connections are tight and there
are no leaks.
Be sure the cylinder cover is clear
of debris. Be sure any component
removed during assembly or
servicing is replaced and fastened
prior to starting.
Heater should be thoroughly
inspected before each use, and
least annually. If re-lighting a
hot heater, always wait at least
5 minutes.
Inspect the hose assembly for
evidence of excessive abrasion,
cuts, or wear. Suspected areas
should be leak tested. If the
hose leaks, replace prior to
operation. Only use the
replacement hose assembly
.
at
17
Advertisement
