Preparing To Work; Checking The Machine - sunjoe SWJ699E-RM Operator's Manual

7. Remove all slack from the chain by turning the chain
tensioner screw clockwise until the chain seats snugly
against the bar with the drive links flush inside the bar
groove (Fig. 7).
NOTE: The chain is correctly tensioned when there is no sag
on the underside of the guide bar; the chain is snug, but can
be rotated by hand without binding. For more information on
chain tensioning, see the maintenance section beginning on
pg. 17.
Fig. 7
8. Tighten the end cover nut completely using the hex key
wrench.
NOTE: If the chain is too tight, it will not rotate. Loosen the
end cover nut slightly and turn the chain tensioner 1/4 turn
counterclockwise. Lift the tip of the guide bar up and retighten
the end cover nut. Ensure that the chain can be rotated by
hand without binding.
NOTE: A new chain tends to stretch; check the chain tension
frequently, and adjust tension as required.
Replacing the Guide Bar + Chain
1. Disconnect the chain saw from the power supply.
2. Use the supplied hex key wrench to unscrew the end
cover nut to remove the chain/sprocket end (Fig. 1).
3. Remove the cutting bar and chain from the mounting
Chain tensioner
Blade
screwdriver
4. Remove the old chain from the bar.
5. To lay out and install the new saw chain properly, follow

Preparing To Work

Checking the Machine

m
adjustments, repairs, or maintenance on the machine, make
sure the unit is not connected to the power supply.
Before starting work, please:
• Check that all the screws on the machine and the guide
• Check that the chain is correctly tensioned, properly
• Check that hand grips and protection devices are clean
• Check that the trigger switch and the safety button move
• Check that the trigger switch remains locked until the
• Make sure the cooling air vents are not clogged with
• Check that the chain's oil level is not below the "MIN"
11
surface (Fig. 8).
Fig. 8
Cutting bar
steps 2 to 6 from the section "Installing the Guide Bar +
Chain" beginning on page 8.
WARNING!
Before performing any checks,
bar are tightly fastened;
sharpened, and there are no signs of any damage;
and dry, correctly mounted, and securely fastened to the
machine;
freely without forcing and return automatically and rapidly
back to their neutral positions;
safety button is pressed;
sawdust or debris;
level mark; if necessary, top up the oil to 1 cm from the rim
of the filler.
NOTE: You must fill the chain oil tank with bar and chain
oil before using your chain saw.
Chain