Table of Contents
Advertisement
UP
Press to raise (warm) the set temperature by 1°C or 1°F.
DOWN
Press to lower (cool) the set temperature by 1°C or 1°F.
°F/°C Selector
Select the temperature display setting in Fahrenheit or Celsius degree. To change the temperature from
Fahrenheit to Celsius or from Celsius to Fahrenheit, touch and hold
TEMPERATURE ZONES
The wine cooler has two temperature zones with a temperature range of 40-64°F. The recommended temperature
setting for each zone is:
•
Lower Zone
between 55-64°F (Ideal for red and white wines)
•
Upper Zone
between 40-55°F (Ideal for sparkling and white wines)
NOTE: The temperature set for the Lower Zone must always be the same or higher than the temperature set for the
Upper Zone. For optimal performance, the set temperature of the two zones should differ by at least 4°F.
SETTING A TEMPERATURE
•
Touch SET
to set the internal temperature for each zone. The degrees indicators will appear in the
display window marked
•
When you touch SET
(preset factory setting for UPPER ZONE is
•
Touch SET
once. The left LED indicator for UPPER ZONE will flash. Then touch UP
to set the desired temperature.
•
When you touch SET
touch the UP
•
The temperature will increase by 1°C or 1°F if you touch UP
by 1°C or 1°F if you touch DOWN
•
To view the set temperature in either zone at any time, touch UP
temperature will temporarily flash in the LED display for 5 seconds. You can touch SET
temperature setting from one zone to the second zone.
NOTE: When using the unit for the first time or after a long period of inactivity, there may be a variance of a few degrees
between the selected temperature and the temperature indicated on the LED readout. This is normal due to the length of
inactivity, and will correct itself after the unit is run for a few hours. If the unit is unplugged, has lost power or is turned off,
wait 3 to 5 minutes before restarting the unit. The unit will not restart before this time delay.
for UPPER ZONE and
for the first time, the LED readouts will show the original temperature settings
again, the right LED indicator for LOWER ZONE will flash. Then proceed to
or DOWN
to set the desired temperature for the LOWER ZONE.
once.
mark for 5 seconds.
for LOWER ZONE.
50°F / 10°C and for LOWER ZONE is 60°F / 16°C).
once, or the temperature will decrease
or DOWN
or DOWN
and the set
to view the
10
0
Advertisement
Table of Contents
