Setting The Controls (Control Type 3 Only); Remove And Empty Bucket - Whirlpool 1187984 Use And Care Manual

Setting the Controls (Control type 3 only)

Starting/Stopping the Dehumidifier
NOTES:
Before turning dehumidifier on, be sure that the bucket is
properly inserted into dehumidifier and that the bucket is
empty.
Each time you unplug the dehumidifier or power is
interrupted, the control will return to your previous settings.
Minimum operating temperature is 44ºF (7ºC).
B
A. Light glows, indicating the bucket is full or is not in correct position.
B. Selects mode.
C. Adjusts amount of moisture removed from room.
WARNING
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in
death, fire, or electrical shock.
1. Plug into a grounded 3 prong outlet.
2. Press ON/OFF to turn on dehumidifier.
NOTE: If the Empty or Adjust Bucket light comes on, the
dehumidifier will not operate. Empty or adjust bucket.
3. Press ON/OFF to turn off dehumidifier.
NOTE: The dehumidifier will retain your last settings.
Empty or Adjust Bucket Light
If this light is on, the dehumidifier is not running. This light
indicates that you need to check:
If the bucket is full, empty and replace bucket.
A
C
If the bucket is not in position, remove the bucket and
replace. Make sure the bucket fits all the way into the
dehumidifier and the light is off, or dehumidifier will not run.
Mode
1. Press MODE to select fan speed.
2. Choose High Fan, Low Fan, Continuous Run or Auto Dry.
High Fan—Will reach the desired moisture level faster.
Press the right arrow button to increase the amount of
moisture removed. The indicator light will change
according to the number of times you press the right
arrow button.
Low Fan—Will reach the desired moisture level slower
with lower sound level.
Press the left arrow button to decrease the amount of
moisture removed. The indicator light will change
according to the number of times you press the left arrow
button.
Continuous Run—Will run continuously regardless of
humidity level.
You cannot select the amount of moisture you want
removed.
The dehumidifier will turn off only if the bucket is full or
removed.
NOTE: The Deicer will turn the compressor off if a low
temperature condition exists. Pressing the left or right
arrow buttons will not increase or decrease the amount of
moisture removed.
Auto Dry—Will provide the maximum humidity control by
automatically adjusting the fan speed and/or turning the
dehumidifier on and off to maintain humidity setting.
Press the left and right arrow buttons to set the amount of
moisture you want removed.

Remove and Empty Bucket

Remove Bucket to Empty Water
WARNING
Sickness Hazard
Do not drink water collected in water bucket.
Doing so can result in sickness.
1. Use side handles to lift bucket. Pull bucket forward and
remove.
5