Fig. 7: Removing The Turbocharger - ABB A130-M65 Operation Manual

Operation Manual / 4 Product description / A130-M.. - A145-M..
2 Removing and Installing / 2.2 Removing the turbocharger
The gas outlet casing (61001) can remain fitted in the exhaust gas pipe if the locking nuts
are accessible. Otherwise the complete turbocharger unit including gas outlet casing must
be removed.
If present: Loosen and remove the compressor wheel cooling connection. Close the com-
u
pressor wheel cooling opening with a screw plug (01).
If present: Disconnect the plug to the speed sensor (86505) and secure the rolled-up
u
cable on the turbocharger. This protects the plug from being crushed.
Fig. 7: Removing the turbocharger
A Oil-cooled bearing casing
B Water-cooled bearing casing
C Position of expansion sleeves
Treat the stud (02) and nut with penetrating oil on the thread and let it work in.
u
If present: Detach the support (61301) from the engine support.
u
Depending on the bracket version (04), two positioning pins (05) can be used for positioning
and safeguarding against wrong fitting of the turbocharger. Therefore the turbocharger
must always be removed from and installed on the bracket vertically.
© Copyright 2018 ABB. All rights reserved.
D Clamping nut
E Standard nut
HZTL4031_EN Revision G October 2018