Maintenance - DeWalt DCS371P1 Instruction Manual

5. The tool's own weight provides the most efficient
downward cutting pressure. Added operator pressure
slows the blade and reduces blade life.
6. End pieces, which would be heavy enough to cause
injury when they drop, after cut-off, should be
supported. Safety shoes are strongly recommended.
End pieces may be hot and sharp.

WARNING: To reduce the risk of serious personal
injury, the brush, brush cap and blade guard
assembly must be installed for one-handed use.
nOTE: The guard assembly is available at extra cost from
your local dealer or authorized service center.
Tips for Better Cutting (Fig. J)
The following recommendations should be used as a guide
(refer to Figure J). Results may vary with the operator and
the particular material being cut.
• Never twist the band saw blade during
cutting operation.
• Never use liquid coolants with portable band saws.
Use of liquid coolants will cause build-up on tires and
reduce performance.
• If excessive vibration occurs during the cut, ensure that
the material being cut is is securely clamped down. If
vibration continues, change the band saw blade.
Fig. J
YES
YES
YES
RECOMMENDED CUTTING POSITIONS
NO
NO
NO

MAINTENANCE


WARNING: To reduce the risk of serious personal
injury, turn unit off and remove the battery pack
before making any adjustments or removing/
installing attachments or accessories. An
accidental start-up can cause injury.
Lubrication
Self-lubricating bearings are used in the tool and periodic
relubrication is not required. In the unlikely event that
service is ever needed, take your tool to an authorized
service location.
Cleaning

WARNING: Blow dirt and dust out of all air vents with
clean, dry air at least once a week. To minimize the risk
of eye injury, always wear ANSI Z87.1 approved eye
protection when performing this.

WARNING: Never use solvents or other harsh
chemicals for cleaning the non-metallic parts of
the tool. These chemicals may weaken the plastic
materials used in these parts. Use a cloth dampened
only with water and mild soap. Never let any liquid
get inside the tool; never immerse any part of the tool
into a liquid.
YES
YES
YES
English
NO
NO
NO
11