Table of Contents
Advertisement
Replacing the Lamp
The projection lamp has a limited life which illuminates the picture.
If the screen becomes dark, the color looks unusual, or the Lamp LED indicator on the front of the RPTV lights
the screen shows message of "PLEASE REPLACE THE LAMP", it is time to replace the lamp with a new one (not
supplied).
(Users should replace the lamp in the television approximately every 6,000 hours to maintain the best possible
image quality. Do not use a lamp past the rated lamp life.) The high-pressure lamp may explode if handled
incorrectly. make sure that the rptv is turned off, power is disconnected, and the lamp is completely cooled
(minimum of 45 minutes) before replacing it. Use only Customer replacement lamps listed below for Replacement.
Use of any other lamps may cause damage to the RPTV.
1. Turn off your RPTV.
2. Disconnect the power cord and all other external cables.
3. Let the lamp to cool completely at least 45 minutes.
4. Remove the lamp access panel screw and remove the access panel.
5. Remove the two lamp module retaining screws.
6. Use the lamp removal handle to lift the lamp module straight out of the lamp bay.
7. Insert the new lamp module into the lamp bay. Make sure not to touch the lamp. The oils from hands can cause
the lamp to fail prematurely.
8. Replace the two lamp module retaining screws. Make sure that the screws are fastened securely to make sure
that the lamp will not shake. Safely discard the used lamp (see page iii about the lamp disposal).
9. Replace the lamp bay access panel, and then replace the access panel screw.
10. Connect the power cable and all external cables.
11. Reset the lamp timer. Please refer to page 32 "Resetting the lamp timer".
5. Remove the lamp module retaining screws.
6. Use the lamp removal handle to pull the lamp module
straight out of the lamp bay.
Remove old lamp
4. Remove the lamp access panel screw
and remove the access panel.
USER SERVICE SCREW.
USER SERVICE SCREW.
VIS POUR ENTRETIEN PAR
VIS POUR ENTRETIEN PAR
LUTILISATEUR.
LUTILISATEUR.
WARNING
WARNING
EYE DAMAGE MAY RESULT FROM DIRECTLY VIEWING THE LIGHT PRODUCED BY THE LAMP
EYE DAMAGE MAY RESULT FROM DIRECTLY VIEWING THE LIGHT PRODUCED BY THE LAMP
USED IN THIS APPARATUS. ALWAYS TURN OFF LAMP BEFORE OPENING THIS COVER.
USED IN THIS APPARATUS. ALWAYS TURN OFF LAMP BEFORE OPENING THIS COVER.
LAMP REPLACEMENT WARNING
LAMP REPLACEMENT WARNING
REFER TO THE INSTRUCTION MANUAL BEFORE REMOVING THE SCREW, DISCONNECT POWER CORD. HOT
REFER TO THE INSTRUCTION MANUAL BEFORE REMOVING THE SCREW, DISCONNECT POWER CORD. HOT
SURFACE INSIDE. ALLOW 45 MINUTES TO COOL BEFORE REPLACING THE LAMP.REPLACE WITH SAME LAMP
SURFACE INSIDE. ALLOW 45 MINUTES TO COOL BEFORE REPLACING THE LAMP.REPLACE WITH SAME LAMP
UNIT ONLY. THIS COVER IS PROVIDED WITH AN INTERLOCK TO REDUCE THE RISK OF EXCESSIVE ULTRAVIOLET
UNIT ONLY. THIS COVER IS PROVIDED WITH AN INTERLOCK TO REDUCE THE RISK OF EXCESSIVE ULTRAVIOLET
RADIATION. DO NOT DEFEAT ITS PURPOSE OR ATTEMPT TO SERVICE WITHOUT REMOVING COVER COMPLETELY.
RADIATION. DO NOT DEFEAT ITS PURPOSE OR ATTEMPT TO SERVICE WITHOUT REMOVING COVER COMPLETELY.
MEDIUM PRESSURE LAMP : RISK OF EXPLOSION. POTENTIAL HAZARD OF GLASS PARTICLES IF LAMP HAS
MEDIUM PRESSURE LAMP : RISK OF EXPLOSION. POTENTIAL HAZARD OF GLASS PARTICLES IF LAMP HAS
RUPTURED. HANDLE WITH CARE.
RUPTURED. HANDLE WITH CARE.
Remove access panel
Replace new UHP 120W LAMP
31
Advertisement
Table of Contents
