Prepare The Hood; Install The Hood - Broan APE130SS Manual

PREPARE THE HOOD

BOTTOM
ALUMINUM
FILTERS
WIRING
COVER
3 Remove the Aluminum Filters, Bottom Cover, and
Wiring Cover from the hood.
VERTICAL DISCHARGE POSITION
HORIZONTAL DISCHARGE POSITION
4 Blower is shipped in Vertical Discharge Position.
To change blower to Horizontal Discharge Position:
Remove Knurled Nuts from Blower Mounting Rods.
Disengage mounting rods from blower and rotate blower
to horizontal discharge position. Re-engage mounting
rods and tighten blower in place with knurled nuts.
COVER
BLOWER
MOUNTING
ROD (2)
BLOWER
KNURLED NUT (2)
BLOWER
MOUNTING
ROD (2)
BLOWER
KNURLED NUT (2)
DAMPER /
DUCT
CONNECTOR
HORIZONTAL DUCT
5 Remove Vertical Duct Knockout or Horizontal Duct
Knockout and attach Damper / Duct Connector with
two (2) screws (supplied).

INSTALL THE HOOD

WARNING
To reduce the risk of electrical shock, switch power off
at service panel. Lock or tag service panel to prevent
power from being switched on accidentally.
MOUNTING
SCREWS (4)
6 Run House Power Cable between service panel and
hood location. Attach power cable to hood using appropri-
ate connector.
7 Hold the hood in position under the cabinet. Make sure
the damper / duct connector enters the Ductwork and
that the damper opens and closes freely.
8 Tighten the four (4) Mounting Screws completely to se-
cure the hood to the cabinet.
APE1 SERIES
Page 3
VERTICAL DUCT
KNOCKOUT
KNOCKOUT
HOUSE
POWER
CABLE
DUCTWORK