Table of Contents
Advertisement
Door Stop/Hinge Adjustment
DOOR STOP
1. Using a 3/16" Allen wrench, remove door stop pin located in bottom hinge.
2. The pin is factory set 110°. For 120° swing, move the pin to the utmost forward stop hole. For 90°
swing, move the pin to the utmost rear stop hole.
HINGE ADJUSTMENT
1. Using a 3/16" Allen wrench, remove the door stop pin located in bottom hinge.
2. Using the height adjustment shim as a wrenching device, rotate the height adjustment bushing
counterclockwise to raise or clockwise to lower the location of the door.
3. When proper adjustment is reached, align shim with door stop pin holes and replace door stop pin.
Firmly tighten pin in place.
120˚ stop
(closest to unit)
90˚ stop
(farthest from unit)
22
Advertisement
Table of Contents
