Related Manuals for GE Monogram ZDOD240HSS
Summary of Contents for GE Monogram ZDOD240HSS
- Page 1 Design Guide with Installation Instructions Outdoor/Indoor Refrigerator ZDOD240 monogram.com...
- Page 2 Proper installation is the responsibility of the For Monogram Parts and Accessories, call 1.800.626.2002. installer. Product failure due to improper installation is not covered under the GE Appliance Warranty. monogram.com KEY EJECTING LOCK CAUTION: Before closing the door, make sure (NOTE: Two keys are included.)
-
Page 3: Table Of Contents
Important Information CONTENTS Important Information Design Guide Installation Instructions Caring for Your Stainless Steel ...... 3 The Installation Space ........4 Grounding the Product ........6 Tools Required............3 Product Clearances and Location Step 1, Remove Packaging ......6 Requirements ............5 Step 2, Level ............ -
Page 4: Design Guide
Design Guide THE INSTALLATION SPACE (cont.) THE INSTALLATION SPACE Flush Installation 1/2" Filler panel or cleat to be set back even with front of case. NOTE: CABINET CABINET Front edge of product case Handle and Front face handle standoff 110° depth is 2-7/8"... -
Page 5: Product Clearances And Location Requirements
Design Guide PRODUCT CLEARANCES AND PREPARATION FOR BUILT-IN LOCATION REQUIREMENTS UNDER-COUNTER INSTALLATIONS ONLY The Outdoor/Indoor Refrigerator is factory set for The top canopy may be removed when installing under a 110° door swing. a countertop. • Remove the three screws from the back of the top When installed in a corner: canopy (A). -
Page 6: Installation Instructions
Installation Instructions GROUNDING THE OUTDOOR/ GROUNDING THE OUTDOOR/ INDOOR REFRIGERATOR INDOOR REFRIGERATOR (CONT.) IMPORTANT: PLEASE READ CAREFULLY. WARNING – FOR PERSONAL SAFETY, THIS APPLIANCE MUST THIS PRODUCT MUST BE CONNECTED TO A POWER BE PROPERLY GROUNDED. SOURCE WITH GROUND FAULT CIRCUIT INTERRUPT The power cord of this appliance is equipped with a 3-prong (grounding) plug which mates (GFCI) PROTECTION WHEN INSTALLED IN AN... -
Page 7: Step 2 Level
Installation Instructions STEP 2 LEVEL STEP 4 SLIDE PRODUCT INTO THE CUTOUT • Use an adjustable wrench to turn and raise or lower the leveling legs. CAUTION: • Measure floor to countertop height inside the opening. Do not push against the door Adjust leveling legs until the product is approximately with your knees. - Page 8 NOTE: While performing installations described in this book, safety glasses or goggles should be worn. For Monogram local service in your area, call ® 1.800.444.1845. NOTE: Product improvement is a continuing endeavor at General Electric. Therefore, materials, appearance and specifications are subject to change without notice. Pub.