GE Monogram ZDWI240WII Dimensions And Specifications

ZDWI240WII – GE Monogram
Dimensions and Specifications (in inches)

Installation Space

Locate Outlet
10-1/2"
9"
Max.
34-1/2"-35"
1-1/2"
23-3/4" Min.
25-1/2"
Including
Handle
The cutout depth must be 24"
The cutout dimensions shown allow for a full door swing and access
to the pull-out racks when installed as a built-in.
• The wine reserve can be free-standing.
Note: If installing between frameless cabinets, a 1/2" wide filler strip
or side panel may be required. The filler strip will act as a spacer
between the door case and adjacent cabinet and will prevent
interference with cabinet door swing. The width of the opening
must include filler panels.
• Wine reserve is vented at the front toekick to allow built-in
undercounter installation.
• Door swing is reversible.
Additional Specifications:
• A 120 volt 60Hz., 15 or 20 amp power supply is required. An
individual property grounded branch circuit or circuit breaker is
recommended. Install a properly grounded 3-prong electrical
receptacle recessed into the back wall as shown. Electrical
must be located on rear wall as shown. Note: GFI (ground fault
interrupter) is not recommended.
Specification Created 10/07
120037
Wine Reserve
®
24"
Cabinet
24" Min.
110˚
24-1/8" Framed models 15" Minimum
23-3/4" Stainless steel
models
34-1/4"-
34-3/4"
23-3/4"

Product Clearances

24"
Cabinet
110˚
14" Minimum
All models are factory set for a 110° door swing.
For a minimum 90° door swing:
• Allow 4" min. clearance to wall on the hinge side.
For a full 110° door swing:
• Allow 14" min. clearance to wall on the hinge side.
Listed by
Underwriters
Laboratories
For answers to your Monogram,
GE appliance questions, visit our website at
®
GEAppliances.com or call GE Answer Center
service, 800.626.2000.
GE Profile or
® ™
®