Table of Contents
Advertisement
Appendix
A. Troubleshooting
Status LED
The following table lists the LED patterns in general.
Condition
Loading system after power on
During booting procedure
Detecting and setting network
After network is setup (system up)
During the upgrade firmware process
Reset and restore
Restoring the factory defaults
will erase any previous settings.
Reset or restore the system after
power on.
VIVOTEK - A Leading Provider of Multimedia Communication Solutions
LED color
Steady blue
Steady blue and red
Steady blue and blink red till IP address is
confirmed
Blink blue every second and steady red
Blink blue every second and fast blink red
There is a button in the back of the Network Camera. It is
used to reset the system or restore the factory default
settings. Sometimes resetting the system sets the system
back to normal state. If the system problems remain after
reset, restore the factory settings and install again.
RESET:
RESTORE:
2. Wait for self-diagnostic to run twice.
3. Free the button as soon as the second
self-diagnostic starts.
- 44 -
Click on the button.
1. Press on the button continuously.
www.vivotek.com
User's Manual -
Advertisement
Table of Contents
