Table of Contents
Advertisement
Vitodens 222-F, B2TB 19, 35, 68, 125 Installation
Side Piping Installation
(continued)
1. Remove the tie-wrap holding the factory installed gas
2. Gently form the fexible gas line by bending the gas
3. Secure the gas line to the centre restraining ring.
1. Install the O-rings over the male connection boiler
2. Slide the insulation sleeve over the DHW pipe
3. Install the pipes through the side cutouts of the
4. Align the pipes to the boiler fittings and push from
5. Secure the ends of the pipes into the appropriate
6. Install the supplied locking clips over the bottom
7. Install security clips to the DHW pipe retaining clips.
line.
line at the middle to the desired side .
IMPORTANT
Ensure not to kink the gas line during bending.
fittings. Ensure that the O-rings are properly seated
in the groove.
(as shown).
boiler.
the top until snug.
restraining rings.
boiler connection and pipes.
Boiler Connections
27
Advertisement
Table of Contents
