To Install In Wireless Lan - Vivotek IP6117 User Manual

self-test, go to next paragraph "Software Installation". If the Ethernet is not available,
the Network Camera will switch to wireless LAN mode.

To install in wireless LAN

If the Ethernet is not available while power on, the Network Camera will search for
any access point with the SSID "default". Once any access point is found, the LED will
turn green to wait for installation. If the network environment cannot meet the
default settings, install Network Camera in Ethernet to proceed with wireless LAN
configuration.
The Network Camera provides a general I/O terminal block with one digital input and
one relay switch for device control. Pin 3 and Pin 4 can be connected to an external
sensor device and the state of voltage can be monitored from the initial state 'LOW'.
The relay switches Pin 1 and Pin 2 can be used to turn on or off an external device.
Consult with the dealer of the peripherals for correct installation.
The Network Camera also provides the auto iris lens connector. If the auto iris lens is
used, AES option in CCD settings must be turned OFF. And you also have to select
VIDEO drive or DC drive lens by select correct iris mode in CCD settings. The pin
assignment of the auto iris lens connector is as follows.
1 SW_COMMON OUTPUT (open from SW_OPEN at initial state)
2 SW_NOPEN OUTPUT (Max. 1A, 24VDC or 0.5A, 125VAC)
3 DI+ INPUT (Max. 50mA, 12VDC)
4 DI- INPUT (Initial state of DI is low)
Video Drive
1. Ground, Shield
2. Not used
3. Video signal
4. Power source
(close with SW_OPEN when set DO to ON)
DC Drive
1. Driver -
2. Driver +
3. Damp +
4. Damp -
www.vivotek.com
T: 886-2-82455282
F: 886-2-82455532