Eco Mode (Eco); To Select The Eco Mode - Casio XJ-A Series User Manual

Eco Mode (ECO)

The following three Eco Mode settings are available to specify whether priority should be given to
low-power, low-noise operation or to projection brightness.
On (Auto) : A brightness sensor on the top of the projector senses surrounding light, and
automatically adjusts projection brightness and color accordingly. Brightness is
reduced for darker surroundings, which saves power and reduces operation noise.
On (Manual): Enables manual adjustment to balance the needs of low-power, quiet operation and
projection brightness.
Off : Give top priority to projection brightness.
Important!
While "On (Auto)" is selected as the Eco Mode setting, make sure that the brightness sensor
on the top of the projector is not blocked by anything.
The local environment and setup conditions affect the brightness sensor, so operation when
"On (Auto)" is selected for the Eco Mode depends on these factors.

To select the Eco Mode

1.
Press the [ECO] key.
This causes "Eco Mode" window to appear on the projection screen.
2.
Use the [ ] and [ ] keys to select the setting you want.
If you select "On (Manual)" here, go to step 3. If you select another setting, jump to step 4.
3.
Perform the following steps to adjust the "Eco Level" (the balance between
low-power, quiet operation and projection brightness).
1 Press the [ ] key to move the highlighting to the Eco Level.
2 Use the [ ] and [ ] keys to adjust the Eco Level to the setting you want.
Fewer marks gives higher priority to projection brightness. A greater number gives high
priority to low-power, quiet operation.
4.
To hide the window, press the [ESC] key.
Note
While "Off" is selected for the Eco Mode setting, you also can specify whether brightness or
color should be given emphasis. For details, see "Image Adjustment 1 3 Eco Off Mode"
(page 58).
Important!
The Eco Mode level is fixed whenever the projector is in the 3D input mode ("3D Input Mode
(XJ-M Series Only)", page 16). Because of this the Eco Mode setting cannot be changed.
53