System Override - Viper 5901 Owner's Manual

sponse will reset.

➢ System override

To disarm the system without a remote control:
You will need to use your Override Switch located on your systems
control center (see diagram below) to disarm the system. The Override
Switch disarms the system only if you have the vehicle key.
To check proper operation:
• Open the door. The alarm will sound.
Immediately insert the key into the ignition and turn it to the RUN or ON
position. (all the indicators in the dash will turn on).
Press the Override Switch once, the alarm should shut off and now the
vehicle should start with the key.
Note: The Override Switch feature allows you to select a specific
number of presses needed to disarm the alarm. If the Override
Switch has been programmed to a new number of presses by your
authorized dealer, that number should be indicated below.
Override Switch Number ___________
© 2008 Directed Electronics. All rights reserved.
1. Texture is same as
*Tolerance please refer specification
2. Radious will be if not specified.
of tolerance limits "c"
INJECT TOLERANCE SPEC.
3. Body color :
A B C
GRADE
± ± ±
DIMENSION
UNDER 6 0.08 0.16 0.30
6~30 0.10 0.20 0.40
30~120 0.20 0.40 0.80
120~300 0.40 0.80 2.00
94I0600
REVISIONS
REV. DESCRIPTION
1
10.44
11.50
CASE P/N:IADGH0A1
KEY P/N:IKDEL0A0
DATE
SCALE: UNIT: DRN BY
M/M VICTOR 11/20/07
1:1
MATERIAL CHK BY
FELIX
FINISH APPD BY
YGF
SIZE
A4
CODE SHEET OF
DRN. DATE
NUTEK
CORPORATION
DEI
TITLE
OLED IVU
DEPT DRAWING NO REV
94I0600 0
25