Table of Contents
Advertisement
Setting Up
Turning the Power On
1.
Connect the plugs of the AC adaptor in
the order shown in the illustration.
DC IN jack (page 10)
2
DC plug
AC adaptor
The shape of the plug and outlet differ depending on the
locale.
WARNING
Use the specified adaptor (page 33) only. The use of other
adaptors may result in irreparable damage to both the adaptor
and the instrument.
CAUTION
Remove the AC plug from the AC outlet when the instrument
is not to be used for extended periods of time, or during
electrical storms.
NOTE
Follow this procedure in reverse order when disconnecting the
AC adaptor.
2.
Press the [P] (Standby/On) switch to
turn the power on.
[P] (Standby/On) switch
Power indicator
If you close the key cover without turning the
power to standby, the power indicator remains lit,
indicating that the power is still on.
When you're ready to turn the power to standby,
press the [P] (Standby/On) switch again for a
second. The power indicator turns off.
12
CLP-625 Owner's Manual
AC outlet
3
1
Power cord
AC plug
Power indicator
CAUTION
Even when the [P] (Standby/On) switch is in the standby
status, electricity is still flowing to the instrument at a
minimum level. When not using the instrument for an
extended period of time, be sure to unplug the power cord
from the wall AC outlet.
Setting the Volume
When you start playing, use the [MASTER
VOLUME] knob to adjust the volume of the entire
keyboard sound.
Level decreases
CAUTION
Do not use this instrument at a high volume level for a long
period of time, to avoid damaging your hearing.
Auto Power Off Function
To prevent unnecessary power consumption, this
instrument features an Auto Power Off function
that automatically turns the power off if the
instrument is not operated for approximately 30
minutes. If you do not want to use the Auto Power
Off function, disable the function as described
below. The setting (disabled or enabled) is retained
even if the power is turned off.
Default setting:
Enabled
Disabling the Auto Power Off function
When the instrument is turned off
While holding down the A-1 key (the lowest key),
press the [P] (Standby/On) to turn the instrument
on. The [REC] indicator flashes three times,
indicating the Auto Power Off function has been
disabled.
Lowest key
Level increases
Advertisement
Table of Contents
