Turning The Power On - Yamaha Arius YDP-164 Owner's Manual

Setting Up

Turning the Power On

1.
Connect the plugs of the AC adaptor in
the order shown in the illustration.
YDP-164, YDP-S54
DC IN jack (page 11)
2
DC plug
AC adaptor
The shape of the plug and outlet differ depending on the
locale.
YDP-144
DC IN jack (page 11)
1
DC plug
AC adaptor
WARNING
Use the specified adaptor (page 40) only. The use of other
adaptors may result in irreparable damage to both the adaptor
and the instrument.
CAUTION
Remove the AC plug from the AC outlet when the instrument
is not to be used for extended periods of time, or during
electrical storms.
NOTE
Follow this procedure in reverse order when disconnecting the
AC adaptor.
For the Power Adaptor with a Removable Plug
Do not remove the plug from the power adaptor. If
the plug is removed accidentally, slide the plug into
place without touching the metallic parts, and then
push the plug in completely until it clicks.
The shape of the plug and outlet differ depending on the locale.
14
YDP-164, YDP-144, YDP-S54 Owner's Manual
AC outlet
3
Power cord
1
AC plug
AC outlet
2
Plug
Slide the plug
as indicated
WARNING
• Make sure to keep the plug attached to the AC adaptor.
Using the plug alone can cause electric shock or fire.
• Never touch the metallic section when attaching the plug.
To avoid electric shock, short circuit or damage, also be
careful that there is no dust between the AC adaptor and
plug.
2.
Press the [P] (Standby/On) switch to
turn the power on.
[P] (Standby/On) switch
Power indicator
Power indicator
If you close the key cover without turning the
power to standby, the power indicator remains lit,
indicating that the power is still on.
When you're ready to turn the power to standby,
press the [P] (Standby/On) switch again for a
second. The power indicator turns off.
CAUTION
Even when the [P] (Standby/On) switch is in the standby
status, electricity is still flowing to the instrument at a
minimum level. When not using the instrument for an
extended period of time, be sure to unplug the power cord
from the wall AC outlet.
NOTICE
Press only the [P] (Standby/On) switch when turning the
power on. Any other operations, such as pressing the keys,
buttons or pedals may cause the instrument to malfunction.