Table of Contents
Advertisement
Gateway ： include IP address （ for example 010.000.000.172 for CMCC ） ； Port
Bearer type：to select the bearer type of network visited, use side up/ down key to highlight
GPRS settings：to change the connection setting of GPRS，select the setting needed to
CSD settings：to change the connation setting of CSD，select the setting needed to
DNS settings
4.9
Calibration
When you feel the phone cannot react accurately after you use the touchpen to tap some place on the
screen, calibration is needed, which ensures the touch screen of phone can react correctly for tapping action.
1. on the screen of "Settings"，tap "Calibration" to enter the calibration screen；
2. use the touchpen to tap the center of cross according to the hint. After three times, the screen
displays "Calibration OK"。
4.10 Reset
If you enable "PIM protect", then when you try to reset you phone, it will pop up "Input security
password". Only if you input the correct password can you carry on Reset settings/Reset all
4.10.1 Reset settings
"Reset settings" is to resume all original default value. After selecting, the mobile phone will prompt
"Reset settings". After confirming, the system resumes the default value and prompts "Reset setting...".
Using this function will not clear the data of phonebook and message saved by you own. It only changes the
setting of the working environment, such as the selection of ring tone and phone modes, etc.
4.10.2 Reset all
"Reset all" is to resume all original default value. After selecting, the mobile phone will prompt "Reset
all？". After confirming, the system will prompt "Deleting all ...". Using this function will clear the data of
phonebook and message saved by you own. After completion, the phone will power off automatically, and it
is needed to restart.
number (for example 9201 for CMCC)；Connect type：to select between HTTP
and WSP。
the type you wanted, tap Select to activate it：
♦ GPRS only：only use GPRS network；
♦ CSD only：only use CSD network。
change, tap Select to enter corresponding window：
♦ APN：to set the name of network；
♦ User name：user name of network service；
♦
Password：password of network service。
change, tap Select to enter corresponding window：
♦ Dial-up number：dial-up number for network service；
♦ Call type：to set the call type between ISDN and Analogue；
♦ User name：user name of network service；
♦ Password：password of network service。
：
input DNS address 1 and DNS address 2。
N6207 User manual
第 34 页
Advertisement
Table of Contents
