Table of Contents
Advertisement
Installation
After you install the software and drivers, connect the dongle
to a free USB 2.0 port on your computer. This powers
the Hub, and the Windows Hardware Installation Wizard
automatically registers the corresponding driver.
Note:
If a previous installation of USB drivers already exists
in your PC, uninstall the previous version using the uninstall
utility (select "Start > Programs > Belkin >").
Install the USB Drivers and GUI
Ensure that your PC system hardware and software are
both operational.
1.
Ensure that the Hub is switched off and the dongle is
unplugged from the PC.
2.
Run the "Setup_ver_07_10.exe" Belkin Setup Launcher
program; follow the on-screen instructions—proceed by
clicking "Next" to install the software to the
default location.
3.
When the Device Driver Installation Wizard appears,
click "Next" to install the device drivers and click
"Continue Anyway" when prompted (four instances).
This will install the required Windows Driver Packages.
4.
Click "Finish".
5.
Click "Finish" again to exit the Wizard.
7
7 7
1
2
3
4
5
6
Advertisement
Table of Contents
