Table of Contents
Advertisement
7. About Hardware
Table 7.1. Specification (2/2)
Item
Digital I/O
Number of input
channels
Number of output
channels
USB
Bus specification
USB transfer rate
Power supply
Common section
Connector
Number of terminals
used at the same time
Power consumption
(Max.)
Operating condition
Physical dimensions
(mm)
Weight
Attached cable
Compatible wires
Standard
*1
The non-linearity error means an error of approximately 0.1% occurs over the maximum range at 0°C and 50°C
ambient temperature.
*2
When using the signal source equipped with the high-speed operational amplifier
*3
This numerical displays the conversion speed for A/D, D/A converter. The minimum executable sampling cycle
depends on the operating condition of the terminal.
*4
You cannot use both the DI00 / DI01 / DI02-pin of digital input feature and the external start / stop signal /
external clock input simultaneously.
*5
Each input accept TTL (5VDC) level signals.
*6
The USB transfer speed depends on the host PC environment used (OS and USB host controller).
*7
As a USB hub is also counted as one device, you cannot just connect 127 USB terminals.
*8
The analog input / output are shared, so cannot trigger set different trigger settings for the same terminal.
62
Unisolated input 4ch (LVTTL positive logic) *4*5
Unisolated output 4ch (LVTTL positive logic)
USB Specification 2.0/1.1 standard
12Mbps (Full-speed), 480Mbps (High-speed) *6
Bus power
14 pin (screw-terminal) plug header
127 terminals (Max.) *7
5VDC 470mA
0 - 50°C, 10 - 90%RH(No condensation)
64(W) x 62(D) x 24(H) (exclusive of protrusions)
90g (Not including the USB cable, attachment)
USB cable 1.8m
AWG28 - 16
VCCI Class A, FCC Class A,
CE Marking (EMC Directive Class A, RoHS Directive)
Specification
AIO-160802GY-USB, AI-1608GY-USB
Advertisement
Table of Contents
