SKAR Audio SK-M9005D Owner's Manual

SKAR Audio SK-M9005D Owner's Manual

Sound quality mini amplifier

Advertisement

Quick Links

Owner's Manual
SK-M5001D
SK-M4004D
SK-M9005D
SOUND QUALITY MINI AMPLIFIER

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the SK-M9005D and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for SKAR Audio SK-M9005D

  • Page 1 Owner’s Manual SK-M5001D SK-M4004D SK-M9005D SOUND QUALITY MINI AMPLIFIER...
  • Page 2: Design Features

    1. INTRODUCTION Congratulations and thank you for purchasing Skar Audio amplifiers, the logical choice in mobile audio amplification. Your amplifiers have been designed and engineered with the highest quality components and top of the line workmanship to help you reach the superior sound you are after.
  • Page 3: Controls And Connections

    MODE ( 2CH/4CH ) match the signal level of different headunits. Selecting 2ch or 4ch input 4-3. SK-M9005D control X-OVER ( 20Hz ~ 500Hz @ 12dB / Oct slope ) The crossover features a steep 12dB oct slope Linkwitz-Riley crossover ensuring that only the highest or lowest frequencies are reproduced by the amplifier.
  • Page 4: Power Connection

    SK-M5001D : 8.5V - 16Volts & 1 ohm mono. SK-M4004D : 8.5V - 16Volts & 2 ohm stereo or 4 ohm bridged SK-M9005D : 8.5V - 16Volts & 2 ohm stereo or 4 ohm bridged for CH1-CH5 and 2 ohm mono for CH5. GND ( GROUND ) Locate a secure grounding connection as close to amplifier as possible.
  • Page 5 4-5. SK-M5001D speaker connection SK-M5001D speaker connection 4 ~ 1 ohms Caution !! SK-M5001D Minimum working impedance is 1ohm. Impedance lower than 1 ohm can damage the amplifier SK-M4004D speaker connection 1. Speker output cable color code Caution !! SK-M4004D Minimum working impedance is 2ohm stereo or 4ohm mono. Impedance lower than 2ohm stereo or 4ohm mono can damage the amplifier...
  • Page 6 CH3 + : Green Caution !! CH3 - : Green with Black SK-M9005D Minimum working impedance is 2ohm stereo or 4ohm bridged CH4 + : Violet for CH1 - CH4 and 2ohm mono for CH5. CH4 - : Violet with Black Impedance lower than 2ohm stereo or 4ohm bridged for CH1-CH4 and 2ohm mono for CH5 can damage the amplifier.
  • Page 7: Troubleshooting

    @ If amplifiers are shut down due to heat, they will be on some minutes later after cooling down. Please make better airflow and no obstruction around amplifiers for thermal protection. @ SK-M5001D, SK-M4004D and SK-M9005D working voltage is 8.5 ~ 16Volts. @ When over 4V DC comes into amplifiers, then, they will be DC protected.

This manual is also suitable for:

Sk-m4004dSk-m5001d

Table of Contents

Save PDF