Table of Contents
Advertisement
p
2. Press
to switch ON the parent unit. The power LED will light up
in green.
3. Press and hold
NOTE
Once the baby and parent units are switched on, the display on the parent
unit will show the video captured by the baby unit.
When there is no connection or out of range, the
display will flash and the parent unit will beep continuously. Move the
parent unit closer to the baby unit until the link is re-established.
2.5
Registration
The baby monitor is already pre-registered upon your purchase. You do
not need to re-register it again unless the baby unit loses its link with the
parent unit.
To re-register your baby monitor, follow the procedure below:
1. Switch off both the baby and parent units.
2. Press and hold
same time to switch it on. The parent unit is in registration mode.
3. Cover the camera lens on the baby unit with a black cloth or bag and
then switch it on.
4. Wait for the 2 units to search and establish the link.
5. Remove the cover on the baby unit.
The registration is complete when the display screen on the parent unit
captures the video from the baby unit's camera.
10
p
to turn OFF the parent unit.
m
, and then press
icon on the LCD
p
on the parent unit at the
Getting started
Advertisement
Table of Contents
