Table of Contents
Advertisement
g All the projectors to be linked are connected in a loop with the daisy chain connection. (Maximum 64 projectors)
g [MODE] on only one projector that is linked is set to [MAIN], and [MODE] on all other projectors are set to [SUB].
g [SHUTTER SYNC] on the projectors to perform the shutter synchronization is set to [ON].
f It is possible to set [SHUTTER SYNC] to [OFF] for the projectors that are linked but not to synchronize.
f The shutter operation by the shutter synchronization function will follow the setting of the [DISPLAY OPTION] menu → [SHUTTER
SETTING] on the projector that [MODE] is set to [MAIN].
f The operation of the mechanical shutter is not included in the shutter synchronization function.
f When the input signal to each linked projector is not synchronized, the timing of the shutter operation between the projectors may shift up to
1 frame while using the shutter synchronization function.
f The shutter function of the projector with [MODE] set to [SUB] can be operated individually. The shutter operation at this time will follow the
setting of the [DISPLAY OPTION] menu → [SHUTTER SETTING] set in that projector.
f The [3D SYNC SETTING] setting is disabled and fixed to [OFF] when [MULTI PROJECTOR SYNC] → [MODE] is set to anything other than
[OFF].
f The following settings are disabled and the contrast synchronization function and shutter synchronization function cannot be used when [3D
SYNC SETTING] is set to anything other than [OFF].
g The [PICTURE] menu → [DYNAMIC CONTRAST] → [USER] → [MULTI PROJECTOR SYNC]
g The [DISPLAY OPTION] menu → [SHUTTER SETTING] → [MULTI PROJECTOR SYNC]
g The [PROJECTOR SETUP] menu → [MULTI PROJECTOR SYNC]
[FREEZE]
Pause the projected image temporarily regardless of the playback of the external device.
1)
Press as to select [FREEZE].
2)
Press the <ENTER> button.
f Press the <MENU> button to release.
Note
f [FREEZE] is displayed on the screen when video is paused.
[WAVEFORM MONITOR]
Use the input signals from a connected external device to display in a waveform. Check whether video output
(luminance) signal level is within the recommended range for the projector and adjust.
1)
Press as to select [WAVEFORM MONITOR].
2)
Press qw to switch the item.
[OFF]
[ON]
3)
Press the <MENU> button two times to clear.
4)
Press as to select any horizontal line.
5)
Press the <ENTER> button to switch the Select line to either luminance, red, green, or blue.
f Line selection items switch each time the <ENTER> button is pressed only when the waveform monitor is
displayed.
"Select line (luminance)"
"Select line (red)"
"Select line (green)"
"Select line (blue)"
Note
f Setting is also available from the [PROJECTOR SETUP] menu → [FUNCTION BUTTON].
f Waveform monitor cannot be displayed while in [P IN P].
f The waveform monitor turns off when the P IN P function is used while the waveform is being monitored.
f The waveform monitor is not displayed when on-screen display is hidden (off).
f Use [3D WAVEFORM MONITOR] to display the waveform monitor with the 3D image.
Chapter 4 Settings — [DISPLAY OPTION] menu
Does not display the waveform monitor.
Displays the waveform monitor.
Displayed in white waveform.
Displayed in red waveform.
Displayed in green waveform.
Displayed in blue waveform.
ENGLISH - 143
Advertisement
Table of Contents
