Table of Contents
Advertisement
[3D COLOR MATCHING]
Switch the color matching correction data applied to displayed image.
1)
Press as to select [3D COLOR MATCHING].
2)
Press qw to switch the item.
f The items will switch each time you press the button.
[SHARED 2D/3D]
[SEPARATE 2D/3D]
Note
f Switch the setting of [COLOR MATCHING] (x page 123) while the signal to be adjusted is being input.
[3D PICTURE BALANCE]
Correct the difference when the images for left eye and right eye have different brightness or color.
1)
Press as to select [3D PICTURE BALANCE].
2)
Press the <ENTER> button.
f The [3D PICTURE BALANCE] screen is displayed.
3)
Press as to select an item, and press qw to adjust the setting.
f Using the left eye image as a reference, the right eye image is corrected using the set value.
f For [3D WAVEFORM MONITOR], the images for the left eye and right eye are split horizontally on the left
and right, and waveforms are displayed.
[CONTRAST]
[WHITE BALANCE HIGH
RED]
[WHITE BALANCE HIGH
GREEN]
[WHITE BALANCE HIGH
BLUE]
[BRIGHTNESS]
[WHITE BALANCE LOW RED] Adjusts the red color of the white balance low.
[WHITE BALANCE LOW
GREEN]
[WHITE BALANCE LOW
BLUE]
[COLOR]
[TINT]
[CLOCK PHASE]
[3D WAVEFORM MONITOR]
Note
f The [CLOCK PHASE] setting is enabled during simultaneous input of RGB1 and RGB2, and is adjusted against the right eye image.
f This function is disabled when [3D SYSTEM SETTING] is set to anything other than [SINGLE].
f This function is disabled when [3D TEST PATTERN] is displayed.
f This function is disabled when [3D TEST MODE] is set to anything other than [NORMAL].
f The 3D waveform monitor is displayed only when the [3D PICTURE BALANCE] screen is displayed.
f The normal waveform monitor cannot be displayed when the 3D image is displayed.
[DARK TIME SETTING]
Set the black display period that is displayed between the right eye image and the left eye image to match the 3D
system in use.
1)
Press as to select [DARK TIME SETTING].
2)
Press qw to switch the item.
f The items will switch each time you press the button.
120 - ENGLISH
Chapter 4 Settings — [3D SETTINGS] menu
Uses same correction data for 2D signal and 3D signal.
Uses different correction data for 2D signal and 3D signal.
Adjusts the contrast of colors.
Adjusts the red color of the white balance high.
Adjusts the green color of the white balance high.
Adjusts the blue color of the white balance high.
Adjusts the dark (black) part of the projected image.
Adjusts the green color of the white balance low.
Adjusts the blue color of the white balance low.
Adjusts the color saturation.
Adjusts the skin tone in the projected image.
Adjusts the image when there is flickering in the image or blur of the outline.
[OFF]
Does not display the 3D waveform monitor.
[ON]
Displays the 3D waveform monitor.
Advertisement
Table of Contents
