Table of Contents
Advertisement
PREPARATION
Set the Current Time and Day
1
Press the CLOCK ADJUST button for more than three
seconds.
2
Press the SET TEMP./DAY button and set the day.
L: Use to advance the day forward.
M: Use to turn the day back.
The day is indicated by a code number from 1 to 7, as shown in the table
below. Set to the number that corresponds to the current day.
DAY CODE
DAY OF THE WEEK
3
Press the SET TIME button and set the time.
L: Use to advance the time forward.
M: Use to turn the time back.
(Press once to move the time 1 minute; hold down and the time will move
10 minutes at a time.)
4
Press the CLOCK ADJUST button again.
This registers the new day and time values. The day display goes off, and
the time display stops flashing.
OPERATION
Instructions relating to heating (*) are applicable only to "HEAT & COOL MODEL" (Reverse Cycle).
To Select Mode Operation
1
Press the START/STOP button.
The unit will start and the remote controller's operation lamp (green) will
light up.
2
Press the MASTER CONTROL button to select the de-
sired mode.
*HEAT
c
To Set the Thermostat
Press the SET TEMP./DAY button to the desired temperature.
L : Press to raise the thermostat setting.
M : Press to lower the thermostat setting.
GThermostat setting range:
* Heating ............................... 16 °C to 30 °C
Cooling ............................... 18 °C to 30 °C
The thermostat cannot be used to set room temperature during the FAN mode
(the temperature will not appear on the remote controller's display).
The thermostat setting should be considered a standard value, and may
differ somewhat from the actual room temperature.
To Stop Operation
Press the START/STOP button.
The remote controller's operation lamp (green) will go out.
The display contents disappear and only the current time is displayed.
3
1
2
3
4
MON
TUE WED
THU
FAN
COOL
c
c
5
6
7
FRI
SAT
SUN
Example: Set the time to 9:31.
NON STOP
CLOCK ADJUST
Example: When set to COOL
Example: When set to 26 °C
CLOCK
AUTO
DAY
1
2
TIMER
SET TIME
TEMP./DAY
FAN
MODE
CONTROL
CLOCK ADJUST
ZONE
ENERGY SAVE
2
3
1
SET
DAY OFF
CLOCK
1
2
CLOCK
TEMP
AUTO
°C
HIGH
1
2
DEFROST TEST
TIMER
SET TIME
TEMP./DAY
FAN
MODE
CONTROL
ZONE
ENERGY SAVE
START/STOP
SET
DAY OFF
NON STOP
CLOCK
TEMP
AUTO
°C
HIGH
1
2
TIMER
SET TIME
TEMP./DAY
FAN
MODE
CONTROL
CLOCK ADJUST
ZONE
ENERGY SAVE
SET
DAY OFF
AUTO
DEFROST TEST
MASTER
CONTROL
START/STOP
AUTO
COOL
MASTER
CONTROL
2
1
AUTO
COOL
DEFROST TEST
MASTER
CONTROL
START/STOP
Advertisement
Table of Contents
