Yaesu FT-857 Operation Manual page 112

M O
ENU PERATION
MENU MODE No-076 [ RPT SHIFT ]
Function: Sets the magnitude of the repeater shift.
Available Values: 0.00 ~ 99.99 (MHz)
Default: Depends on operating band and transceiver version.
MENU MODE No•077 [ SCAN MODE ]
Function: Selects the desired Scan-Resume mode.
Available Values: TIME/BUSY/STOP
Default: TIME
This Menu Item allows you to select your favorite method of scan-restart after the scanner
has stopped on an incoming signal (when the squelch opens).
TIME: The scanner will hold for a fixed length of time, set via MENU MODE No-078
[ SCAN RESUME ] , then resume whether or not the other station is still transmitting.
BUSY: The scanner will hold until the signal disappears, then will resume after one second.
STOP: The scanner will stop when a signal is received, and will not restart.
MENU MODE No•078 [ SCAN RESUME ]
Function: Sets the delay time for scanning resumption.
Available Values: 1 ~ 10 (sec)
Default: 5
MENU MODE No•079 [ SPLIT TONE ]
Function: Enables/disables split CTCSS/DCS coding.
Available Values: OFF/ON
Default: OFF
MENU MODE No-080 [ SQL/RF GAIN ]
Function: Selects the configuration of the front panel's SQL/RF knob.
Available Values: RF-GAIN/SQL
Default: Depends on transceiver version.
MENU MODE No-081 [ SSB MIC GAIN ]
Function: Adjusts the microphone gain level for the SSB mode.
Available Values: 0 ~ 100
Default: 50
MENU MODE No-082 [ SSB STEP ]
Function: Selects the tuning steps for the SELECT knob on the SSB mode.
Available Values: 1 kHz/2.5 kHz/5 kHz
Default: 2.5 kHz
110 FT-857 Operating Manual