Daikin FTXM20UVMZ Operation Manual page 31

„ Titanium apatite deodorizing filter (included with the air conditioner) /
dust collection filter (PM2.5) (sold separately)
Attaching
1.
Open the front panel and
pull out the air filters.
2.
Insert the titanium apatite
deodorizing filters or dust
collection filters (PM2.5).
• Check that the filters are inserted securely under the tabs.
Cleaning and Replacement
1.
Open the front panel and
pull out the air filters.
2.
Take off the titanium apatite
deodorizing filters or dust
collection filters (PM2.5).
• Remove the filters from the tabs.
NOTE
• Operation with dirty filters:
− cannot deodorise the air,
− cannot clean the air,
− results in poor cooling,
− may cause odour.
• Dispose of old filters as non-flammable waste.
Page 29
Filter
Tab
Page 29
Filter
Tab
3.
Clean or replace the
titanium apatite deodorizing
filters or dust collection
filters (PM2.5)
[Cleaning for titanium apatite
deodorizing filter (Blue-Black)]
3-1 Vacuum dust, and soak in lukewarm
water or water for about 10 to
15 minutes if very dirty.
3-2 After washing, shake off remaining
water and let them dry in the shade.
• This filter can be renewed by washing it with water
once every 6 months and we recommend
replacing it once every 3 years.
• Do not wiring out the filter when removing water from it.
[Cleaning for dust collection filter
(PM2.5) (White)]
• Do not wash the filters as this will reduce their efficiency.
• It is recommended to replace it once every 6 months.
[Replacement]
Remove each filter from the
front grille by detaching them
from the 6 tabs and then install
the new filters.
• When attaching the filter, check that the filter is
properly set in the tabs.
4.
Set the filters as they were
and close the front panel.
• Press the front panel at both sides and the center.
Care
30