Table of Contents
Advertisement
Route Planning options
Regional settings
Warnings
Hardware button (Power on/off)
You can use TRAX436 mostly by tapping the touch screen. The device
has only one hardware button for turning power on or off.
When the device is on, pressing the power button momentarily turns the
LCD screen off (the green LED stays on and the device continues to
operate) or on. Press and hold the power button to turn the device off.
You can turn the devices on or off at any time. When the device is
switched off, TRAX436 does not calculate your GPS position and it does
not update the route or the driving instructions.
When you turn the device on again, TRAX436 continues navigating as
soon as the GPS receiver has determined your position.
Buttons and other controls on the screen
When you are using TRAX436, you usually tap buttons on the touch
screen.
You only need to confirm selections or changes in TRAX436 if the
application needs to restart, it needs to perform a major reconfiguration, or
you are about to lose some of your data or settings. Otherwise, TRAX436
saves your selections and applies the new settings without confirmation as
soon as you use the controls.
Type
Example
Button
Yes
Yes
Only
Yes
language
selection
No
Yes
Description
Tap it to initiate
a function, to
open a new
screen, or to set
a parameter.
How Do I Use It?
See page
105
See page
107
See page
110
How to use it
Tap it once.
Page 19
Advertisement
Chapters
Table of Contents
