Table of Contents
Advertisement
SECTION 4 — OPERATION
3.4 Standard Display Functions
4.2.7 Standard display functions:
Reachable after long encoder button press (~3s) and indicated by flashing 3 LED diodes
To save changes, press long encoder button (~3s)
A
Activity Time
SERVICE Functions
A.8.8.8.
8.
1.0.'
.
A.8.8.8.
8.
2.4.'
'.
t.8.8.8.
8.
1.0.'
.
T.8.8.8.
8.
2.6.'
'.
C.U.8.8.
8.o.F.F.
C.U.8.8.
8.8.O.n.
C.U.8.8.
8.6.O.n.
E.r.8.2.
8.8.8.4.
C.O.d.E.
-.-.-.-.
16
MIG 500
USER Configuration Menu
T
Total ON Time
drU
Control PCB Current Status
Activity time (hours)
Activity time (minutes)
Total ON time (hours)
Total ON time (minutes)
Cooling Unit
Error Register
Error Register
Service Code Enter
MIG400
Power Source
User Configuration Menu
C.U.
Cooling Unit Control
CodE
Service Code
USER
Shows time how long current flow was detected
Shows time how long device was ON
Cooling unit disconnected or not active.
Signal from cooling unit is ignored.
Cooling unit is connected.
Stand-by function not active.
Cooling unit is connected.
Stand-by function active
Active only in communication mode
Set time range 2..30min
Display counter for each type of error
(during service mode long press will reset all counters
and display text ErCL)
Function available only once correct start-up sequence
Enter correct service code by turning encoder and press
button to access service functions
Er.
Errors Register
conducted (2).
11
Advertisement
Table of Contents
