Operation - NewArc Mig500 Operational Manual

3. Operation

Front panel operation
This design is based on microprocessor technology and allows to implement set of functions previously not
available in Newarc inverters:
• Encoder based function control - digital settings
• Hot start control
• Operation time control
• Welding duration (resettable user counter available as an optional extra)
• Error identification and counter
• Mode changing
• Cooling unit control
• Improved remote control
Configuration
Front Panel is factory calibrated and in most cases doesn't need additional adjusting. If any problem occurs
please contact service for advice. To check set maximum parameters and mode access use function "Settings
Check" (Start-up Display)
Software
By default both the current and voltage displays show four dashes when not welding. When current flows, panel
shows actual current and voltage on display.
Every other function is accessible by short pressing encoder down and turning encoder anti- or clockwise for the
correct value.
13
MIG 500