T70/T80 - Tunturi T70 Owner's Manual

T70/T80

UPRIGHT TUbES
Connect the wire coming out of the left upright tube.
Fasten each upright tube to the lower frame with four
bolts. Be careful not to damage the wire coming out of
the upright tube.
notE! Do not remove the bolts, but slide the upright
tube over the bolts, and tighten by turning the bolts
COUNTER CLOCKWISE.
Place the plugs in the holes after tightening the bolts to
cover up. The plugs are self-adhesive (remove protection
before applying).
HANDLEbAR AND CONSOLE
Connect the wire coming out of the left handlebar with
the connector in the console and push the connected
wire inside the handlebar. Push the console unit onto
the handrail ends and tighten all the hex screws on the
upright tubes.
Apply the 4 bolts and washers to secure the Console on
the upright tubes. After lining up the console, fasten the
bolts.
Connect the Sensor wires from the left handlebar and
slide the wire into the tube coming from the console.
3
T70 & T80 - OWNER'S MANUAL ENGLISH