Operating Sequence - LG LD-2263WH Owner's Manual

OPERATING SEQUENCE

Open the door and Press
the "power" button
When you press the "power" button, the
state of default program being set will be
displayed.
Check that there is rinse
aid and salt
The corresponding indicator lights will
illuminate if refilling is necessary.
Check the filters
Ensure they are clean and properly
positioned (See "User Maintenance
Instructions").
Load the dishes
Remove any scraps of food.
Pull the lower rack out and arrange the
dishes and cutlery in it.
Pull the upper rack out and arrange the
cups, glasses, etc. in it.
CAUTION
Do not load the items in upper rack with
the lower rack is pulled out and loaded.
Ensure that the spray arms
can rotate freely
Measure out detergent
Add the required amount of detergent into
the dispenser. Close the detergent
dispenser lid.
Setting and starting the
program
Push the course button to select the
program.
If necessary, select the option function
corresponding to the desired program.
The indicator lights of the program and all
the phases the program consists of will
come on.
Before starting, the display window shows
the running time of the selected program.
To start, close the door.
Select if necessary the washing on only
one rack by pressing the half load button.
Remember to load all dishes into
the selected rack.
The time in the display window will start
to decrease from minute to minute.
If the door is opened during the run of the
program a safety device ensures that the
machine stops.
Once the door is closed the program will
start from the point where it was
interrupted.
At the end of the washing
program
After operating, buzz sound informs you
that the program has ended and the
dishwasher automatically switches off for
safety and energy saving.
Empty the lower rack first and then the
upper one;this will avoid water dripping
from the upper rack onto the dishes in
the lower one.
In general it is not advisable to open the
door while the machine is working;
If the door is opened however, a safety
device ensures that the machine stops.
Care must be taken if the door is opened
during the hot phase or immediately after
a program has finished, as steam may
escape.
That the door should not be left in the
open position since this could present a
tripping hazard.
19
CAUTION
WARNING
CAUTION