Operating Sequence - LG DW-TS610S Owner's Manual

O
PERATING SEQUENCE
Press the Power button
Check there is rinse aid
and salt
The corresponding indicator lights will
illuminate if refilling is required.
Open the door and check
the filters
Ensure they are clean and properly
positioned. (See User Maintenance
Instructions)
Load the dishes
Remove any excess food.
Pull the lower rack out and arrange the
dishes and cutlery.
Pull the upper rack out and arrange the
cups, glasses, etc.
CAUTION
Do not load the items in upper rack
when the lower rack is pulled out and
loaded.
Ensure the spray arms can
freely rotate
Measure out detergent
Add the required amount of detergent into
the dispenser and close the lid.
Setting and starting the
programme
Press the programme button to select the
desired programme.
After 10 seconds, the machine will start.
If necessary, select the option function
corresponding to the desired programme.
The indicator lights of the programme and
all the phases of the programme will come
on.
All manuals and user guides at all-guides.com
26
Before starting, the display window shows
the running time of the selected
programme.
After starting, the display window shows
the remaining time.
The time in the display window will start
to decrease minute by minute.
If the door is opened during the
programme a safety device ensures that the
machine stops.
Once the door is re-closed the programme
will start from where it was interrupted.
At the end of the washing
programme
End is displayed on the digital display and
a buzzer sounds.
And the dishwasher automatically switches
off for safety and energy saving later.
If you select UV function, the dishwasher
automatically switches off after sterilising
action.
CAUTION
Empty the lower rack first and then the
upper one; this will avoid water dripping
from the upper rack onto the dishes
below.
WARNING
In general it is not advisable to open
the door while the machine is working.
If the door is opened, a safety device
ensures that the machine stops.
Care must be taken if the door is
opened during the hot phase or
immediately after a programme has
finished, as steam may escape.
CAUTION
The door should not be left in the open
position since this could present a
tripping hazard.