Kenwood TK-8360E Instruction Manual page 16

2 Press the key programmed as Status or Selcall + Status.
• When pressing the Status key, the target Fleet/ ID is fixed and cannot be
selected. Skip to step 5 to continue.
3 In Selcall mode, press
<B/C> to select the ID of the station you want to call.
• You can also enter the station ID directly by using the keypad.
4 Press S to enter Status mode.
5 Press / (if the key assignment list selection is configured as "Enabled") or <B/C> to select
the status ID you want to transmit.
• You can also enter the status ID directly by using the keypad.
6 Press the PTT switch or ■ to initiate the status call.
■ Receiving
When a status call is received, the
on the display. Press any key to return to normal operation.
■ Reviewing Messages in the Stack
1 Press and hold the key programmed as Stack, Selcall, Status, or
Selcall + Status.
2 Press / (if the key assignment list selection is configured as "Enabled") or <B/C> to select
your desired message.
3 Press to return to normal operation.
S /L M
HORT ONG
To send and receive short or long messages, connect the transceiver to a PC. (Ask your dealer for
details.)
• Short messages can contain a maximum of 48 characters. Received short messages
are displayed the same as Status messages and are stored in the same stack memory.
A combined maximum of 15 Status calls and short messages can be stored in the stack
memory.
• Long messages can contain a maximum of 4096 characters and can only be viewed via
a PC.
GPS R
EPORT
If a GPS unit (NMEA-0183 format) is installed on your transceiver, you can press the key programmed
as Send the GPS data to send your location data.
12
/ (if the key assignment list selection is configured as "Enabled") or
ESSAGES
icon will flash and the calling ID or text message will appear