Configuration Menu - ETC Penko SGM700 Series Manual

MANUAL SGM700
3.1

Configuration Menu

Press button 3 >2 sec to enter the Configuration Menu.
In the Configuration Menu the following options are available:
- - - Fun
- - - ACn
- - - Fun
- - - dAC
- - - ACn
- - - dAC
- - - Eth
- - - 485
- - - - Pb
- - - Eth
- - - 232
- - - CAn
- - - 422
- - - - Pb
- - - Ind - - - Ind
- - - 232
- - - rng
- - - rng
- - - 422
- - - FIL
- - - FIL
- - - dSF
- - - dSF
- - - PCL
- - - PCL
- - - CAL - - - CAL
- - - tCL
- - - tCL
- - - gCL - - - gCL
- - - CLo - - - CLo
- - - rcL
- - - rcL
- - - SoF - - - SoF
Scroll thru the menu options pressing key 1 and enter a sub-menu pressing key 2
<2 sec.
setpoint function settings (not for SGM710 or controller)
setpoint action settings (not for SGM710 or controller)
setpoint function settings (not for SGM710)
Analog output settings
setpoint action settings (not for SGM710)
Analog output settings
Ethernet settings (SGM720 only)
Local bus communication settings (RS485)
Profibus settings (SGM740 only)
Ethernet settings (SGM720 only)
RS232 port settings (SGM750 only)
Can bus port settings (SGM730 only)
RS422 port settings (SGM750 only)
Profibus settings (SGM740 only)
Indicator settings Indicator settings
RS232 port settings (SGM750 only)
Multi range/interval settings
Multi range/interval settings
RS422 port settings (SGM750 only)
Filter settings
Filter settings
Digital filter settings
Digital filter settings
Pre-calibration settings
Pre-calibration settings
Calibration settings Calibration settings
Theoretic calibration
Theoretic calibration
Geographic calibration Geographic calibration
Date and time configuration (SGM750 only) Date and time configuration
Recall
Recall
Firmware update Firmware update
35