Sealey LED100C Instructions

Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these
instructions, and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
Refer to
instructions
1. SAFETY
1.1. GENERAL SAFETY
DO NOT shine directly into your, another person's or an animal's eyes.
8
DO NOT allow children to use the torch.
8
DO NOT use the torch if you suspect that the battery or the torch casing is damaged.
8
DO NOT leave batteries in a discharged state. Before storage remove batteries and dispose of in the correct manner.
8
1.2. BATTERY SAFETY
WARNING! To reduce the risk of burns or fire:
‰
DO NOT attempt to open the batteries.
8
DO NOT crush, puncture, short contacts or dispose of in fire or water.
8
DO NOT expose to temperatures above 60°C (140°F).
8
Replace only with the batteries designed for this product.
9
Recycle or dispose of used batteries as stipulated by local regulation.
9
If the electrolyte in the batteries gets on your skin, thoroughly wash with soap and water. If it gets in your eyes, rinse thoroughly with
9
cool water and seek immediate medical attention.
2. INTRODUCTION
3W COB LED that produces up to 250lm. Made from tough ABS plastic with a moulded grip and a soft finish. Clamp opens up to 3
inches. Lamp can be separated from the grip and used as a small hand held torch or mounted to any magnetic surface. Features
360 degree rotating ball joint to allow for greater coverage. Requires 3 x AA batteries (not Included)
3. SPECIFICATION
Model No.:............................................................. LED100C
Batteries: ............................................... 3 x AA (not included)
LED qty.: ........................................................... 1 x 3 W COB
Lumen output: ............................................................ 250 lm
Operating time: ............................................................. 5 hrs
4. OPERATION
4.1. REMOVING LAMP FROM CLAMP
4.1.1. The lamp can be removed from the clamp mount by
depressing the small tab on the underside of the lamp
mounting base and sliding the lamp upwards and away
from the tab.
4.2. BATTERY
4.2.1. To insert or replace batteries, twist and separate the light
housing and light mounting base in opposite directions
to expose the battery compartment.
4.2.2. Insert the new batteries according to the polarity markings
in the base and reassemble the unit.
4.3. ON / OFF SWITCH
4.3.1. To turn the light on depress the button (fig.1). One further
press of the button will turn the light off.
NOTE: When the lamp is separated from the clamp it can be mounted to any magnetic surface or used as a small hand held torch.
© Jack Sealey Limited
3W COB LED WORKLIGHT WITH CLAMP
LED100C
MODEL NO:
fig.1
Original Language Version LED100C Issue 1 18/09/20