Advertisement
16
Drivers may be mounted on top of luminaire if suitable for your application.
Only mount drivers on top of luminaire if it is readily accessible, such as a
dropped tile ceiling. Position the driver in the center of luminaire and secure
using 1/4" #8 screws (by others). Do not mount drivers between segments.
Note: Driver size and location of mounting holes may differ from below example.
17
Make wiring connections from driver to 1st PCB. Pull lead wires from luminaire
and make splice connections to lead wires from driver. Verify wiring diagram
before connecting.
18
Perform a continuity test before connecting luminaire to power source.
Refer to page 20 for continuity test step by step.
19
Verify driver wire colors from wiring diagram, then connect luminaires to power
source. Drivers used for this product vary. Always confirm wiring diagram from
driver installation instructions before connecting.
20
Apply mud to Wall Trim until completely covered and smooth. Allow to dry
completely before painting or sanding. Do not use pre-mixed mud compounds.
21
After all installation steps are complete and lighting is confirmed to be working,
install reflective film to runs.
Note: Follow the steps on page 19 to install reflective film.
CALIFORNIA ACCENT LIGHTING, INC.
2820 E. Gretta Lane, Anaheim, CA 92806
ph. 800.921.CALI (2254) | fx. 714.535.7902 | info@calilighting.com | calilighting.com
© CALI. All rights reserved. CALI reserves the right to make changes or withdraw specifications without prior notice.
Lead Wire
ALS500T-SWM-FG
INSTALLATION INSTRUCTIONS
Mounting (Aircraft Cable Assembly) 3 of 3
4 / 2 / 2022 / Rev 4
Page 13 of 20
Advertisement
