CALI alumLEDs ALS500T-SWM-FG Installation Instructions Manual page 12

Adjust Cable Gripper by unscrewing locking mechanism. Press down and hold

the threads where cable feeds through. Pull cable from the exit. Let go of threads

to lock in place, then replace locking mechanism.

Unscrew & lift

Slide luminaires onto Aircraft Cable Assemblies. Adjust positioning of lower hex

nut if needed to allow assemblies to slide in easily. Always install corners first.

If applicable, install end cap to end of run.

CALIFORNIA ACCENT LIGHTING, INC.

2820 E. Gretta Lane, Anaheim, CA 92806

ph. 800.921.CALI (2254) | fx. 714.535.7902 | info@calilighting.com | calilighting.com

Press down & hold

Pull cable

Slide luminaires onto

Aircraft Cable Assemblies

ALS500T-SWM-FG

Mounting (Aircraft Cable Assembly) 2 of 3

After all luminaires have been mounted, secure Aircraft Cable Assemblies to

luminaire by tightening lower hex nuts. All aircraft cables must rest in a vertical

position. Do not allow aircraft cables to rest at a slant or angle. Adjust as needed.

Note: The position of the Aircraft Cable Assemblies may deviate from the

spacing diagrams due to variations within the installation area. Ensure all

luminaires are appropriately balanced.

Tighten hex nuts

to secure in place

Secure connections between continuous runs using Connector Blocks after all

luminaires have been mounted.

Note: Refer to steps on page 17 for details.

Install Ceiling Trim after all luminaires have been mounted and connected.

Note: Follow the steps on page 18 to install Ceiling Trim.

After all luminaires are mounted, adjust height and levelness of each luminaire

by adjusting cable gripper. Allow the weight of the luminaire to be suspended by

the aircraft cable while simultaneously resting on the flange of the T-Bar.

Note: One person holds the luminaire and another person adjusts cable gripper.

INSTALLATION INSTRUCTIONS

Adjust length as needed

Trim excess cable

Ceiling Trim resting on T-Bar

4 / 2 / 2022 / Rev 4

Page 12 of 20