Communication Responses - PCB Piezotronics ICP 483C30 Installation And Operating Manual

Signal conditioner

Table of Contents

MODELS 483C30, 483C50, 482M179 AND 483M217 GENERAL OPERATION MANUAL

Command interpretation: Unit=1;channel=1;'WTED='; 36 = bytes in the message payload (values after the

'=' sign);0 = DO NOT write to the application register if it exists; 0 = write to page 0; 23-117 are the 32 bytes

to be written into the TEDS chip EEPROM memory; 221 is the calculated checksum of B0-Bn-1

Setting Response: 1:WTED:ok

Possible error responses: -21 - TEDS Write Buffer is too Big (> 44 Bytes)

Query:

N/A

Communication Responses

Typically the unit will return <Unit>:<Cmd String>:OK when the command is successful. Errors are indicated with

negative numbers. The unit may return one of the following:

Signifies that the last command was entered in the correct format and was performed properly.

Option Error. The unit is not equipped with the option necessary to implement the command sent

Channel Error. The channel number in the command is invalid.

Command Error. The command is not recognized.

Unit Error. The unit number in the command is invalid.

Unit Error. The function invoked by the command encountered an error or a query only command (ex.

RBIA) was sent as a setting.

Command Parameter Error. A channel setting parameter was found to be out of range.

-22 - TEDS Write Buffer CS Failure

Table of Contents