Advertisement
YM-410D
ASSEMBLY
x
Insert the rails (2), (3) and (4) into the frame ends of the legs.
2-1. First, insert the rail (2). Make sure that the end of the rail with the tone bar posts spaced
further apart is positioned on the bass side.
A mark "B" is printed on the large end face of the rail (2) and the groove section of the
frame end of the large end leg.
* Do not insert one side of the rail all the way down first, but push both sides into grooves alter-
nately little by little until both sides are inserted fully and stop.
Rail (4): With YAMAHA logo. Logo side facing the audience.
High register side
2-2. After confirming that legs on the left and right sides are vertical, use
the screw to connect the end of the stay to the hole for attaching
the stay in the long frame (2) and firmly tighten the screw.
2-3. Next, in the same way, insert the rails (3) and (4) securely.
A mark "C" is printed on the large end face of the rail (3) and the
groove section of the frame end of the large end leg, and a mark "D"
for the rail (4).
2-4. Engage the short rail clamp located
at the center of the rail (3) with the
rail (2).
36
(3): Both sides have clamps attached. The side with the shorter clamp should face the player.
(2): Hole for attaching the stay. The side with the threaded hole should face the audience.
Audience side
(1)
Tone bar posts
B
C
D
Slant shaft
A
Player side
Frame end
Bass side
Rail (2)
Advertisement
