Chapter 3 Basic Operations — Operating with the remote control
Operating with the remote control
Switching the input
The input for projection can be switched.
button
1)
Press the input selection (<RGB1/2>, <DIGITAL LINK>, <DVI-D>, <VIDEO>, <DisplayPort>, <HDMI>)
buttons.
f This operation can be also performed using the <INPUT> button on the control panel.
<RGB1/2>
<DIGITAL LINK>
<DVI-D>
<VIDEO>
<DisplayPort>
<HDMI>
Note
f When the optional Digital Interface Box (Model No.: ET-YFB100G) is connected to the <DIGITAL LINK/LAN> terminal, the ET-YFB100G
input changes with each press of the <DIGITAL LINK> button. The input can also be changed using the control command of RS-232C.
For twisted-pair-cable transmitters of other manufacturers, switch the input on the projector to DIGITAL LINK, and then switch the input on
the twisted-pair-cable transmitter.
Using the shutter function
If the projector is not used for a certain period of time during the meeting intermission, for example, it is possible to turn off the image and
audio temporarily.
button
1)
Press the <SHUTTER> button.
f The image and audio disappear.
f This operation can be also performed using the <SHUTTER> button on the control panel.
2)
Press the <SHUTTER> button again.
f The image and audio reappear.
Switches the input to RGB1 or RGB2. Switches to another input when one input has already been
chosen.
Switches the input to DIGITAL LINK.
Switches the input to DVI-D.
Switch the input to VIDEO.
Switches the input to DisplayPort.
Switch the input to HDMI.
ENGLISH - 49