TYT TC3600 Manual page 13

Disable/Enable Scan Feature
1. Press scan key, scanning begins.
2. Press scan key again, scanning ends.
LED flashes green in scan mode.
Callback
Pressing PTT during scanning can callback on the callback channel. Please contact
your dealer for more details.
Nuisance Delete
Nuisance delete feature allows you to temporarily delete an unwanted channel from the
scan list.
When the radio stops on the nuisance channel, press the programmed "nuisance delete"
key until an alert tone sounds to delete this channel.
When scan feature is enabled again, the deleted channel will return to the scan list.
Note: Priority channel can't be deleted.
Priority Channel Scan
This feature allows you to scan important channels frequently. The dealer can program a
channel as priority channel through the programming software. Please contact your
dealer for more details.
Channel Scan: Ch1 Ch2 Ch3 Ch4 Ch5...Ch1
Priority Channel Scan（Ch2 is priority channel） ：
Ch2 Ch1 Ch2 Ch3 Ch2 Ch4 Ch2 ...Ch1
Note: The radio will constantly monitor the priority channel when it stops on a
non-priority channel. If an activity is detected on the priority channel, the radio will move
to and remain on the priority channel.
Call
Press the programmed call key, the radio will sound a series of rings to call and wake
the radio that has the same channel and signaling to draw the user's attention.
Selective Call
The radio can call selected radios if selective call feature is set. It includes selective call
and group call. Selective call is used to call a selected radio and group call will call a
group of radios.
Transmit
1. Hold down PTT key and then press the programmable key [B], the radio will transmit
a series of programmed selective call signaling code. (The user can edit selective call
list through the menu. Please refer to Chinese/English menu.)
2. Hold down PTT and then press the programmable key [C], the radio will transmit a
series of programmed group call signaling code.
3. When transmission ends, the radio enters call waiting mode. When the called radio
receives the signaling, it will send a confirmation tone to your radio.
4. Then press PTT to talk.
5. When the call waiting reset time elapses, MONI key is pressed or channel selector
knob is rotated, the radio will exit the call waiting mode.
Receive
1. When your radio receives a selective call signaling code or group call signaling code
13