Getting Started; Inserting The Batteries; Setting Up The Universal Remote; Control - Philips SRP2104/27 User Manual

Philips universal remote control 4in1 tv/vcr/dvd/sat
Hide thumbs Also See for SRP2104/27:
Table of Contents

Advertisement

2
G etting started
2.1
Inserting the batteries
I nsert 2 AAA type
batteries, noting
the + and -
configuration in the
battery
compartment.
Note
When replacing the batteries, all user settings
will be retained in the remote control
memory for 5 minutes.
2.2
S etting up the universal remote

control

The example below instructs you how to set
up your universal remote controls for your TV.
You can repeat the same steps for other devices
(DVD player/recorder, Cable/Satellite box and
VCR) which you want to operate, using the
SRP2104.
The remote control can be set up to operate
any 4 of the following devices:
Device name
Description
TV
T raditional TV, flat screen
TV and projection TV, TV
part of TV / VCR, TV / VCR
/ DVD and TV / DVD
combos
DVD
D VD player / recorder
(DVDR), DVD / Hard
Disk Drive combination
(DVDR-HDD), Blu-Ray
player, High Definition
DVD player (HD-DVD),
DVD part of TV / DVD, TV
/ VCR / DVD and VCR /
DVD combos
4
EN
CBL/SAT
C able box, satellite
receiver, Internet Protocol
TV (IPTV), Free To Air TV,
High Definition Television
decoder (HDTV) and Tivo
VCR
V ideo cassette player /
recorder, Personal video
recorder (PVR), VCR part
of TV/VCR, TV/VCR/DVD
and VCR/DVD combos
Example: s etting up the universal remote
control to operate your TV:
1
S witch ON the TV manually or use the
original remote control for this. Tune to
channel 1.
2
P ress and hold the
device selection
button for 5 seconds
until the red Setup
light remains lit .
The remote control
is now in setup mode.
3
L ook up the 4-digit
code for your brand
in the brand list at
the back of this user
manual.
A 4-digit code is
shown for each brand.
U se the digit
buttons to enter
the code for your
brand.
• I f the red Setup
light turns off,
an invalid code
was entered. In this case, try again.
4
A im the remote
control at the TV.
Press and hold the
button. Release
it immediately as
soon the TV
switches off.
• T his step normally takes between 5 and
60 seconds. In extreme circumstances
this step can take up to 15 minutes.
5 sec.
5-60 SEC.
5 - 60 sec.
EN
5

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Srp2104

Table of Contents